This is the area to clarify hardware specification if there's anything unclear from the datasheet. If the specification is software related, please ask in the related software section.

UP board heat spreader mounting holes dimensions

candura
candura New Member Posts: 10 ✭
in UP Board Hardware Specification

Hi, I'm looking for 2d/3d drawings of the heat spreader (not heat sink) for the UP Board. I don't see it at the current community download page, but at some point in the past it was available - I was able to use it to determine the mounting holes positions. Unfortunately I didn't save that file.

· Share on Facebook

Comments

  • candura
    candura New Member Posts: 10 ✭

    Good thing I kept files in my 'Download' folder for years. I found the zip file that contains the .dwg file of the part in question (M16UPCH020).

    Can a .STP file be make available as well? The tapered-punch out part of the plate is not trivial to re-create in 3d. Thanks.

    · Share on Facebook
  • raresh_p
    raresh_p New Member Posts: 6 ✭

    Hi, could you repost the DWG file ? I don't seem to find it anywhere and would help me a lot to create a custom plate for the UP.
    Thank you!

    · Share on Facebook
  • candura
    candura New Member Posts: 10 ✭

    For some reasons the forum doesn't let me post the file here, even if it's just a jpg file. I can email to you. Hopefully admin sees this and add their DWG file back into the Download section.

    · Share on Facebook
  • raresh_p
    raresh_p New Member Posts: 6 ✭

    Sure, that would be great !

    · Share on Facebook
  • candura
    candura New Member Posts: 10 ✭

    Let's see if this works.

    · Share on Facebook
  • raresh_p
    raresh_p New Member Posts: 6 ✭

    Thanks a lot ! Meanwhile I have recreated the pattern in direct measurements and I was "about" there. The spacing is a lot more clearer now.
    Thank you.

    · Share on Facebook

Categories

Privacy Policy