10-pin connector CN7 (UART0) - Which FTDI serial cable to use?
m
New Member Posts: 15 ✭
Hi!
I have a question regarding the "10-pin connector CN7 (UART0)" which I hope to get an answer to. I want to buy a FTDI serial cable to use together with the 10-pin connector CN7, but there exist FTDI cables with different currents (3.3V, 5V, etc.). Does anyone know which current is the right one?
Thank you very much!
I have a question regarding the "10-pin connector CN7 (UART0)" which I hope to get an answer to. I want to buy a FTDI serial cable to use together with the 10-pin connector CN7, but there exist FTDI cables with different currents (3.3V, 5V, etc.). Does anyone know which current is the right one?
Thank you very much!
Comments
-
3.3V is the right one to use.
More info on how to wire the cable can be found here: https://up-community.org/wiki/Serial_console -
Great! Thank you.
I was actually reading that page, but information about the voltage was missing. Maybe it is a good idea to add this information. -
Just added, thanks for reporting!
-
Thanks for adding!
