Overvoltage (12v) in Upboard - How to recover data
I, unfortunately, overvoltaged the board with 12v. I was able to boot a couple of times but now the screen appears completely black all the time when I power it. I noticed that when I booted the consumption was 2Amps and now it just consumes 1 amp.
I found two questions about the same topic https://forum.up-community.org/discussion/2069/now-that-i-fried-my-only-up-board , https://forum.up-community.org/discussion/comment/8806#Comment_8806 and it seems that there is not any possibility to recover the board.
I am trying to read how to (somehow) recover the information in the eMMC. is it possible? I hope there is a way of entering to some recovery mode with minimal usage to read the eMMC content.
Any advice will be appreciated.
EDIT: I am trying to move the post to the right forum but I cannot, I am referring to this version of UpBoard https://www.mouser.es/ProductDetail/AAEON-UP/UP-CHT01-A22-0432-A11?qs=XeJtXLiO41S0JpGxYUwwTg==&vip=1&gclid=Cj0KCQjwpfHzBRCiARIsAHHzyZp5Xa62d5NyrGmaaJTqPYxNenGVujjHTFcOzXlk02nNI2dJcbBT8uQaAuaZEALw_wcB
- 292 All Categories
- 104 Announcements & News
- 48 Product News - New Product/Product Change Notice/ End-of-life
- 181 Welcome Developers!
- 49 Unboxing & Project Sharing
- 20 Tech Updates
- 411 UP Products
- UP 4000
- 12 UP Xtreme i11
- 21 UP Squared 6000
- 40 UP Squared Pro
- 132 UP Xtreme
- 797 UP Squared
- 1.4K UP Board
- 86 UP Core Plus
- 217 UP Core
- 3 UP Xtreme Lite
- 41 UP AI Edge
- 213 Starter Kits & Peripheral