This is the area to clarify hardware specification if there's anything unclear from the datasheet. If the specification is software related, please ask in the related software section.

Issue Powering USB Camera using USB 3.0 OTG Port

samperid
samperid New Member Posts: 1 ✭
in UP Board Hardware Specification

Hello,

I am working on a project where I would like to use my Up Board to power a USB camera which requires USB 3.0 compatibility and 3.2 watts of power. I have bought a USB 3.0 to micro USB b adaptor to interface with the Up Board however, when I plug everything in the camera does not seem to be recognized by the downloaded software or is powered (indication via LED). I set up the BIOS according to wiki for device mode as well. Any help would be greatly appreciated.

Thanks,
Dylan

· Share on FacebookShare on Twitter

Comments

Categories

Privacy Policy