Unable to get any output from the HDMI
Sally
New Member Posts: 6 ✭
I have been trying to setup my UP2 following the quick start guide. I have installed a Windows 10 bootable USB drive, connected a USB keyboard and mouse, connected the supplied HDMI cable to the UP2 and a monitor, and connected the power supply to the UP2 and switched on.
I then waited for the UP BIOS logo for over 30 minutes without any sign of any output. I then switched off the power and changed the HDMI cable and switched the power back on and again waited for the BIOS logo to appear to no avail. I also tried a different display without any luck.
Is there something I'm doing wrong?
Any help would be gratefully received.
I then waited for the UP BIOS logo for over 30 minutes without any sign of any output. I then switched off the power and changed the HDMI cable and switched the power back on and again waited for the BIOS logo to appear to no avail. I also tried a different display without any luck.
Is there something I'm doing wrong?
Any help would be gratefully received.
Comments
-
Do you see the blue LED is on ?
-
I discovered it was the brass standoffs shorting something. I'm going to have to get some nylon standoffs or 3D print some.
-
Has anyone else experienced this problem, as perhaps it is something which requires further investigation?
-
I think there are a few UPs users with the same problem as I found the answer on this forum post:https://up-community.org/forum/general-discussion-up2/2179-up-2-no-signal-either-display-port#5930
