Which ethernet device is being used on UP2 board?
sheham
New Member Posts: 1 ✭
Hello,
We're using the UP2 board. And i am trying to load the VxWorks kernel onto it through UEFI bios. VxWorks kernel does boot up, but i get this error:
ERROR: ipcom_drv_eth_init: drvname:gei, drvunit: 0
In order to figure out this issue, i need to know what sort of network device is being used in this board? (Like, for Intel's Leaf Hill reference board, it's Intel Ethernet Controller I210). I couldn't find this sort of information on the UP wiki pages.
Regards,
Mahesh.
Comments
-
@sheham
here is the hardware specification for network https://wiki.up-community.org/Hardware_Specification_UP2#NetworkWhat version VxWorks you are using ?
