This is the area to clarify hardware specification if there's anything unclear from the datasheet. If the specification is software related, please ask in the related software section.
Which ethernet device is being used on UP2 board?
sheham
New Member Posts: 1 ✭
Hello,
We're using the UP2 board. And i am trying to load the VxWorks kernel onto it through UEFI bios. VxWorks kernel does boot up, but i get this error:
ERROR: ipcom_drv_eth_init: drvname:gei, drvunit: 0
In order to figure out this issue, i need to know what sort of network device is being used in this board? (Like, for Intel's Leaf Hill reference board, it's Intel Ethernet Controller I210). I couldn't find this sort of information on the UP wiki pages.
Regards,
Mahesh.
Comments
-
@sheham
here is the hardware specification for network https://wiki.up-community.org/Hardware_Specification_UP2#NetworkWhat version VxWorks you are using ?
