After powered Up Board with 7.4 Volts Lipo battery, USB Ko

PhilDou
New Member Posts: 3 ✭
Dear,
I use an Up Board under Ubilinux. I have install and use it with success.
I try to make a drive robot, but to powered the Up Board I have inadvertently connect the power to a LIPO battery 7.4 Volts. The Up board have correctly running, but after, when I have try to reconnect to the standard power, the Up Board doesn't start. I have disconnect the battery 30", then reconnect the power. Up Bord strats normally except the 4 USB ports which doesn't work. Idem the USB 3 port doesn't work. Juste the USB port near the GPIO works correctly.
Have you a solution ?
In advance thank you.
Best regards
Philippe
Categories
- All Categories
- 105 Announcements & News
- 54 Product News - New Product/Product Change Notice/ End-of-life
- 185 Welcome Developers!
- 55 Unboxing & Project Sharing
- 48 Tech Updates
- 693 UP Products
- 11 UP 7000
- 1 UP Squared i12
- 10 UP Xtreme i12
- 11 UP Squared Pro 7000
- 1 UP Element i12 Edge
- 19 UP Squared V2
- 59 UP 4000
- 24 UP Xtreme i11
- 35 UP Squared 6000
- 60 UP Squared Pro
- 143 UP Xtreme
- 837 UP Squared
- 1.4K UP Board
- 89 UP Core Plus
- 222 UP Core
- 3 UP Xtreme Lite
- 44 UP AI Edge
- 216 Starter Kits & Peripheral