up board, Mimo DisplayLink touch screen and Windows 10 Enterprise

JB
New Member Posts: 2
Good evening everyone,
I have successfully installed Windows 10 Enterprise on an up board and a Mimo DisplayLink touch screen. It works perfectly, BUT:
after switching off the display due to energy settings the system don't react to a touch to the display.
Only by moving the mouse or striking a key on the keyboard the display (and the touch screen) will come back to life.
Entering energy saving mode is disabled.
Any ideas what could cause this problem?
Best regards,
Joerg
I have successfully installed Windows 10 Enterprise on an up board and a Mimo DisplayLink touch screen. It works perfectly, BUT:
after switching off the display due to energy settings the system don't react to a touch to the display.
Only by moving the mouse or striking a key on the keyboard the display (and the touch screen) will come back to life.
Entering energy saving mode is disabled.
Any ideas what could cause this problem?
Best regards,
Joerg
Categories
- 301 All Categories
- 104 Announcements & News
- 51 Product News - New Product/Product Change Notice/ End-of-life
- 184 Welcome Developers!
- 52 Unboxing & Project Sharing
- 24 Tech Updates
- 549 UP Products
- 1 UP Xtreme i12
- UP Squared Pro 7000
- 1 UP Element i12 Edge
- 11 UP Squared V2
- 25 UP 4000
- 24 UP Xtreme i11
- 34 UP Squared 6000
- 44 UP Squared Pro
- 140 UP Xtreme
- 819 UP Squared
- 1.4K UP Board
- 89 UP Core Plus
- 221 UP Core
- 3 UP Xtreme Lite
- 43 UP AI Edge
- 215 Starter Kits & Peripheral