Problem with the Firmware update upa1am21 for UP2!

Michael Wachs

Hello,

when I enter the firmware setup after installation of this update, I'll be asked for the administration password!
I've never set a firmware password!

Would you please publish the password?

Thanks in advance,
Michael

WereCatf

Just press enter.

Michael Wachs

I did it before writing this thread!
Some setup parameters, which were accessable before update, are blocked/read-only now.

WereCatf

Well, like the Wiki says, those are probably behind the password upassw0rd

Michael Wachs

Sorry, I didn't find this information in the Wiki.

I tried this password "upassw0rd" successfully, but I can't reset/disable it for the future! There is no way to do it in the firmware setup.
Can you tell me, how to do that?

Thanks in advance,
Michael

Michael Wachs

I have to apologize for my hasty reaction! I found the way.

David Rolfe

Could you perhaps share it with us, in case others experience similar problems?

Thanks!

Michael Wachs

After entering the firmware by pressing <DEL> or <ESC>:
<CRB Setup> --> <CRB Security> --> <Setup Administration Password>.
I pressed <RETURN> without any password input...