-
Re: Does anyone know how to use the UART connection on the UP Xtreme i11?
@SimonB UART and RS232 are not the same. The i11 's CN11 that outputs UART using 0 ~ 3.3V TTL level. So, you'll need a UART to RS232 converter. More information about RS232. FYI. RS232 Protocol – Bas…1 · -
Re: HDMI over usb c port
@Pasc No, the USB-C port does not support display output, only USB 3.2 Gen21 · -
Re: How Can I Read Analog Input From GPIO Pins
@voxventi You can refer to the link below. It should be the same with UP board https://freva.com/dht11-temperature-and-humidity-sensor-on-raspberry-pi/1 · -
Re: I can't access the ubilinux iso file
@voxventi The link is working fine, try it again http://ubilinux.org/download/iso/v4.0/ubilinux-installer-4.0.iso1 · -
Re: How to power UP board with battery to read 2 USB devices
@rgehlhar Is the DC-DC converter 5V output too low to power the second USB device at startup?1 ·