ccalde ✭✭✭

Hello @inselbuch, Please check the output using lshw or dmidecode (check options) commands to get more specific info about your hardware. Thank you.

Hi @Jvv , Could you please try to access to your BIOS and go to Advanced -> HAT Configurations and switch your PWM to GPIO mode? It should be enough for your question, right?

Hi @pgugi , To enable the WiFi and BT on UP Core board you will need to install the Ubuntu 16.04.5 with our upboard kernel 4.15 via PPA. After that, you have to install the Ampak firmware via PPA as …

Hi @savan, Your Python version is fine. You must only use "upboard-image-sato" to build the meta-up-board layer.

Hi @Jari , Could you please specify more about your setup? GPIO pin? Sensor model? Steps to load and check your sensor on Linux, etc. I would like to reproduce the issue here. Thanks!