Not working after BIOS-Update
Kai Klintworth
New Member Posts: 23 ✭
Hi.
I just did the BIOS-Update to UPA1AM21 according your steps. It went through all steps and there were no faults during update. After update the system did a reboot but nothing happens anymore. The blue light next to the power input is on but I don't get any signal to the display. It keeps dark. On the backside all 4 lights are on, blue, orange, green and red.
What can I do now???
My system: N4200/8GB/64GB
Regards
PS: I disconnected the battery for 30 seconds and put it in again. But no help.
I just did the BIOS-Update to UPA1AM21 according your steps. It went through all steps and there were no faults during update. After update the system did a reboot but nothing happens anymore. The blue light next to the power input is on but I don't get any signal to the display. It keeps dark. On the backside all 4 lights are on, blue, orange, green and red.
What can I do now???
My system: N4200/8GB/64GB
Regards
PS: I disconnected the battery for 30 seconds and put it in again. But no help.
Comments
-
It is possible the board is bricked, something went wrong during the BIOS reflash.
If you still cannot fix it, you may send it back for RMA. -
Any hint how I can fix it?
-
Same here with same model N4200/8GB/64GB
-
Now they put a warning to the bios download page:
WARNING: do not flash this BIOS version on UP Squared Innovator boards (EVT2).
So bios is NOT for innovator board. -
What are the options now?
Can't see description of or meaning of EVT2. -
You have to contact the Customer service at shop@up-board.org and tell them your problem.
-
Thanks, will do
-
UP collected bricked board and have sent me a replacement.
