-
Re: GPIO use
@toinas some are listed ion this wiki page: https://wiki.up-community.org/Verified_HATs1 · -
Re: Up Board using MRAA unable to initalize gpio
@rameshgm81 You also need to install the correct kernel for the UP2, the generic kernel does not have support for the GPIO header. See here and here1 · -
Re: Power Supply Specs UP Squared
No, @ccalde said you can use the5 5V and 3.3V input pins and supply 1A to each of them. There are 2 5V pins and 2 3.3V pins, so that would make 4A total. However, you do not need to supply 3.3V only …1 · -
Re: [SOLVED] Accessing ADC pins in UP2 board
As far as I know he UP2 does not have any ADC pins only the UP has 1 ADC pin. And even if it had some, there is no mention of ADC pins in the pinctrl driver for the UP2, so you would not be able to u…2 · -
Re: Ethernet power supply standard
Why is this confusing? If there is nor information at all about PoE, then that should tell you that it is not supported. The Board is designed to be powered via the 5V DC jack, but Aeeon said that yo…1 ·